These two custom vacuum chambers are custom sized and designed to fit inside another chamber, with specified ports for the vacuum line, venting valve and any other feedthroughs the customer will need in the future. Made from 304L stainless steel with 316L stainless steel sockets. Clear cast acrylic lid with nitrile ‘L’ gasket. one 15L […]
This is a lovely example of our VC-12-VF vacuum cylinder model available at www.vacuum-belljars.com This one has been customised with the inclusion of a 100mm 0-50mbar vacuum gauge for some added accuracy of their experiments.
Vacuum Bagging Vacuum bagging is a very flexible process for consolidating fibre-reinforced polymer laminates of a wide range of shapes and sizes. The composite to be consolidated (e.g. a prepreg or hand lay-up) is placed on a single-sided mould. The material is then covered with an impervious film (the “vacuum bag”), which is sealed around […]
Here are two fully stainless steel custom sized 8ltr vacuum chambers with acrylic lids made for a customer in the aerospace industry. These high quality chambers are constructed with 304L stainless steel bodies and 316L stainless manifold. The customer is using water in some of their experiments and needed a chamber that would be more […]
This custom Bell Jar system houses 3 x 12kV electrical feedthroughs and an earthing point for the customer to perform various tests on their products. The pump supplied with it is a DVP.LC4 which has an ultimate pressure of 2mbar. The system is fitted with a digital gauge accurate to ± 0.25% FS, and a […]
This system was completely designed from the top down to fully automate the degassing and casting process from start to finish at just the press of a button by the end user. The software controls the opening and closing of all of the corresponding solenoid valves and opening and closing of the pneumatic pinch valve […]